5365-01-276-9782

A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside_diameter_or_smallest_overall_outside_dimension_is_designated_as_a_tolerance/dimension_the_maximum_dimension_will_be_used_to_determine_compliance._excludes:gasket;_insulator_(as_modified)_and_mounting_pad,_electrical-electronic_component.____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

0.970 inches minimum and 1.030 inches maximum overall length, 0.250 inches nominal hole diameter, irregular shape; bolt hole located 0.350 in. from center of bolt hole to left edge along width and 0.500 in. from center of bolt hole to edge along length; spacer rounded w/ 0.620 radius from left edge to 0.350 in. along width and from right top edge to 0.350 in. along length; 0.650 in. of thickness is 0.190 in. and 0.350 in. of thickness is rounded to 0.040 in. on left side; left spacer plate special features, 1 bolt hole quantity, aluminum alloy 2024 material