thread length 1.062" head diameter 0.75" head height 0.312" thread diameter 0.19"

Steel 11 in. lg 3.82 in. w 1.17 in. h

Plastic, 0.42 in. lg, 0.35 in. dia

Anodized finish 0.438 in. od, 0.35 in. lg 0.266 in. id with 0.15 in. min 0.156 in. max diameter hole 0.25 in. deep, 0.15 in. min 0.156 in. max dia hole thru od 3/8-32 nef-3a thd on small end used on actuator assy part no. 12c1450-811 f-111 acft

Item consists of fork end part number a-mbeu-36439, stud part no.a-mbeu-1766h5, 0.093 inch diameter indent pin part number ds9-a10, 0.062 inch diameter rivet part no. as155-206, used on seat assembly part number mbeu36726, seat installation pilot ejection

rubber material sectional height cross 0.069-0.075" center hole diameter 0.409-0.419"

quantity 3 test set and repair shop equipment

Body of cast aluminum ams 4217 doubler and van coating of 0.062 in. thickness rubber synthetic ams 3302

width 1" length 35.5-36.5" both with attachments

thread size 0.312" Color yellow iridescent flange thickness 0.16"

Steel 5.25 in. lg 2.38 in. w 2.68 in. h

Consists of connector tube part no. a8720 and adapter tube part no. a8722 used on leg assy front part no. a8597-20 hh-1h aircraft

Consists of connector tube part number: a8720 and adapter tube part number: a8722 used on leg assembly front part number. a8597-10 hh-1h aircraft

Cadmium plated finish 1.01 in. diameter hole in connector tube part no. a-8729 0.316 in. diameter hole in adapter tube part no. a-8730 used on seat assembly part no. a-8599-20 hh-1h aicrcraft

width 4" diameter 36" Used to provide mold when replacing liner

Resonant Frequency 600 hertz Test set electronic systems specially designed aircraft

diameter 4.50" F100-pw-100/200/220/229 engine Used as a gearbox drive bevel gear shaft base during engine component repair

Length: 0.75 thread length: 0.187 aluminum alloy 5365000011292.

Length: 1.94", width: 1.44", height: 1.19", torque tester

Used during aircraft maintenance to hold the altimeter during repairs

length 6" width 4" height 6"

with read out meter with special tip mounted on sensor

Aircraft Maintenance Fixture width 14.75 height 20

Length: 11 width: 4.25 height: 1.17 material: steel

Cadmium plated finish 1.01 in. diameter hole in connector tube part no. a-8729 0.316 in. diameter hole in adapter tube part no. a-8730 used on seat assembly part no. a-8599-10 hh-1h aircraft

remote control lever nsn 3040-00-005-0006

length: 54 inches diameter: 0.75 inches to hold disk and hubs during hydraulic clamping

height 4" diameter 4" F100 pratt and whitney 100/200/220 aircraft engine