5365-01-276-9784

A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside_diameter_or_smallest_overall_outside_dimension_is_designated_as_a_tolerance/dimension_the_maximum_dimension_will_be_used_to_determine_compliance._excludes:gasket;_insulator_(as_modified)_and_mounting_pad,_electrical-electronic_component.____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

shape irregular; d imensions-1.000 in. top width,0.600 in. bottom width,0.960 in. left side length,and 0.700 in. rt side length; bottom rt corner cut out; bolt hole located 0.420 in. from rt edge to bolt hole center along width and 0.480 in. from edge to bolt hole center along length; thickness is 0.190 in.,rt edge rounded to 0.040 in. thickness; right spacer plate special features, mil-t-9046 fed spec single material response material document and classification, titanium alloy uns r56400 material, 0.343 inches nominal hole diameter, 1 bolt hole quantity