5365-00-112-2172

A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside_diameter_or_smallest_overall_outside_dimension_is_designated_as_a_tolerance/dimension_the_maximum_dimension_will_be_used_to_determine_compliance._excludes:gasket;_insulator_(as_modified)_and_mounting_pad,_electrical-electronic_component.____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

4.320 inches minimum and 4.330 inches maximum aperture diameter, 2 bolt hole quantity, 4.880 inches nominal outside diameter, 4.540 inches nominal bolt circle diameter, 0.135 inches minimum and 0.141 inches maximum hole diameter