1560-00-310-5186

Find complete technical information, availability, and procurement data for: 1560-00-310-5186
DODParts.com distributes related products varnishes dopes paints, aircraft parts and consumables, electrical parts, fittings and other components for the aerospace and defense industries. Submit the short price quote form for NSN 1560-00-310-5186 to receive an up to date pricing and availability quote by email.

Federal Supply Group

Aerospace Craft and Structural Components

Federal Supply Classification

1560 Airframe Structural Components

National Stock Number

1560-00-310-5186

Cancelled

This item was cancelled on: 01/01/1963.

A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes:disk, valve, graphite impregnated and lubricated items.

1560-00-310-5186, no name available

FAQs

Find helpful answers about installation, operation, maintenance, compliance, and troubleshooting.

What is the FSCG of the NSN 1560-00-310-5186?

The FSCG of the NSN 1560-00-310-5186 is 1560

Does NSN 1560-00-310-5186 require demilitarization?

Usml items - mutilation to the point of scrap required worldwide. (note 7).

Does NSN 1560-00-310-5186 contain precious materials?

Precious metal content is unknown

Does NSN 1560-00-310-5186 contain hazardous materials?

Indicates there is no information in the hmirs. The nsn is in a fsc in table ii of fed std 313 and a msds may be required by the user. The requirement for a msds is dependent on a hazard determination of the supplier or the intended end use of item.